1985 Mercedes Benz 190D AutomaticFACTORY OEM SERVICE PROCEDURE

EGR System - Diesel: Operation

The EGR system operates with vacuum from the vacuum pump. Vacuum is applied to the center connection of vacuum control valve. The modulated vacuum from the vacuum control valve outlet controls the operating vacuum to the EGR valve via the vacuum amplifier.

The vacuum amplifier regulates the modulated vacuum according to load condition (accelerator position). The vacuum control flap is vacuum actuated and activated by the ECU via a switchover valve. Full closing vacuum is then applied to the actuator, closing the vacuum control flap.

With the vacuum control flap closed, the vacuum in the intake manifold increases, causing more exhaust gas to be recirculated. Engine RPM and vehicle speed are picked up by the RPM sensor and processed by the ECU. The vacuum control flap and the EGR valve are opened or closed by switchover valves, depending on operating conditions of the engine.

During EGR operation, a portion of the exhaust gas is routed into the intake manifold via exhaust gas return line and the EGR valve.

Fig 1: EGR Component Layout (California - M/T)
G38906
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.