1981 Mercedes Benz 280CEFACTORY OEM SERVICE PROCEDURE

System Check

  1. Start engine and warm to operating temperature. Air pump clutch should be disengaged and pump should be stopped.
  2. Disconnect plug from coolant switch and insert jumper wire into connector terminals. Turn ignition off and then on without starting engine. Clutch and switchover valve should operate.
  3. Connect negative lead of voltmeter to terminal 3 of diagnostic plug (on fenderwell). Connect positive lead of voltmeter to battery. With engine running at operating temperature, voltage should be present. Mark voltmeter dial to indicate needle position, then stop engine.
  4. Remove connector from magnetic clutch on air pump. Use jumper wires to connect clutch terminals to ground and battery voltage. Start engine and observe voltmeter. Reading should be as previously marked. Disconnect vacuum lines from switch-over valve and connect them together. Voltmeter reading should increase. If not, proceed to component testing.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.