Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
MERCEDES-BENZ 1972 Engine Modification With Fuel Injection: Description
The emission systems used on models with fuel injection are similar in function, however some of the components differ. The 280 SE and 600 models utilize a 17°C (100°F) oil temperature switch and a 100°C (212°F) coolant temperature switch, while all other models have only the 100°C (212°F) coolant switch. A gulp valve is used on 280 SE and 600 models only. This valve provides additional air to the intake manifold during periods of deceleration. A Throttle solenoid is used on 280 SE models only. The solenoid prevents engine from stalling when engaging transmission. All fuel injection models incorporate a two-way valve in the vacuum line to control ignition timing vacuum advance and retard. An RPM relay is used on 280 SE and 600 models.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
