Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2024 Mazda CX-90 PHEV PreferredFACTORY OEM SERVICE PROCEDURE
DTC U0182-00: Communication Error With Auto Leveling Control Module/Adaptive Led Headlights Control Module/Adaptive Front Lighting System (AFS) Control Module
U0182:00 (BCM) DETECTION CONDITION AND POSSIBLE CAUSE
| System malfunction location | Communication error with auto leveling control module/AFS control module/adaptive LED headlight control module | |
|---|---|---|
| Detection condition |
|
|
| Fail-safe |
|
|
| Vehicle status when DTCs are output | Not applicable | |
| Repeatability verification procedure | 1. Clear the DTC recorded in the memory. (See CLEARING DTC .) | |
| Inspection/action procedure | β’ Proceed with the inspection/action in the order from Step 1 below. β’ After part repair or replacement, perform the repeatability verification procedure and perform a DTC inspection. (See DTC INSPECTION .) - If the DTC inspection indicates the same DTC again, go to the next step. 1. Perform the malfunction diagnosis according to the troubleshooting procedure for the multiplex communication system. |
|
| Purpose/reason (possible cause) | Malfunction in CAN communication line between the auto leveling control module/AFS control module/adaptive LED headlight control module and the body control module (BCM) | |
| Referred to service information item | MALFUNCTION DIAGNOSIS FLOW [CONTROLLER AREA NETWORK (CAN)] | |
| System wiring diagram |
|
|
| Function explanation (DTC detection outline) | β’ Not applicable | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
