2024 Mazda 3 Preferred, 4D HatchbackFACTORY OEM SERVICE PROCEDURE

Reading Operation Records Of FSC: Notes

  1. Connect the M-MDS to the DLC-2.
  2. Switch the ignition ON (engine off or on)/main power ON (READY off or on).
  3. Activate the M-MDS and perform the following procedure.
    1. Press [Start] to start the vehicle identification.
    2. Press the [Toolbox] tab.
    3. Press the [Diagnosis] icon.
    4. Press [Operational records].
    5. Press [i-ACTIVSENSE].
    6. Press [Reading Operation records of FSC].
  4. Verify the record of operation according to the directions on the screen.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.