2023 Mazda CX-5 SFACTORY OEM SERVICE PROCEDURE

Front Power Window Motor Inspection: Driver-side

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
  2. Remove the front door trim. (Driver-side) (See FRONT DOOR TRIM REMOVAL/INSTALLATION .)
  3. Disconnect the front power window motor connector.
  4. Apply battery positive voltage and connect the ground to front power window motor terminals E and F, and then inspect the front power window motor operation.
    B+ Terminal Ground Terminal Operation
    E F Close
    F E Open
    Fig 1: Front Power Window Motor Circuit Diagram
    G11448981Courtesy of MAZDA MOTORS CORP.
  5. Connect the battery positive voltage to front power window motor terminal D and connect terminal C to ground.
  6. Operate the front power window motor and verify the wave patterns for terminals A and B.
    Fig 2: Wave Pattern For Terminal A And B Of Front Power Window Motor
    G11275137Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.