Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2023 Mazda CX-5 SFACTORY OEM SERVICE PROCEDURE
Power Window System Initialization Procedure
NOTE:
- If the following operations have been performed, the initial settings are reset, and auto operation is disabled.
Therefore, performing the initial setting is necessary.
- Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
- Disconnect the power window main switch connector.
- Remove the power window system power supply fuse.
- Disconnect the power window subswitch connector.
- Switch the ignition ON (engine off or on).
- Press each power window main switch or power window subswitch to fully open the door glass.
- Pull up and hold each power window main switch or power window subswitch until the door glass is fully closed. Once fully closed, keep holding the switch up for approx. 2 s or more.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
