Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2022 Mazda 3 BaseFACTORY OEM SERVICE PROCEDURE
Function Inspection
WARNING: This page is about a different variant/trim than selected.
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off).
- Display the PCM PIDs [MAP_VOLT] and [MAP]. (See PID/DATA Monitor InspectionΒ .) (See PID/DATA MONITOR TABLE [PCM (VIN Y)] .)
- Compare the voltage and manifold absolute pressure indications for the PIDs [MAP_VOLT] and [MAP] with the standard in the table indicated below.
- If they do not match the standard, perform the voltage inspection. (See Voltage InspectionΒ .)
STANDARD
| MAP_VOLT | MAP | Remarks |
|---|---|---|
| V | kPa {kgf/cm2 , psi} | |
| Approx. 1.73 | 101 {1.03, 14.6} | Ignition switched ON (engine off) |
| Approx. 0.74 | 33 {0.34, 4.8} | Idle (after warm up) |
| Approx. 0.63 | 26 {0.27, 3.8} | Racing (Engine speed: 2, 000 rpm) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
