2022 Mazda 3 BaseFACTORY OEM SERVICE PROCEDURE

DTC U2300-54: Configuration Data Not Received From Body Control Module (BCM) [Adaptive Front Lighting System (AFS) Control Module]: Outline

WARNING: This page is about a different car, the 2021 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
DTC U2300:54 [ADAPTIVE FRONT LIGHTING SYSTEM (AFS) CONTROL MODULE] DETECTION CONDITION AND POSSIBLE CAUSE

System malfunction location Configuration data not received from body control module (BCM)
Detection condition
  • The adaptive front lighting system (AFS) control module cannot receive the configuration data from the body control module (BCM).
Fail-safe When the adaptive front lighting system (AFS) control module has not been configured.
  • The swivel actuator is moved to the center.
  • Control of the headlight auto leveling system is continued.

    When the adaptive front lighting system (AFS) control module has already been configured.

  • Control of the adaptive front lighting system (AFS) is continued.
  • Control of the headlight auto leveling system is continued.
Possible cause
NOTE:
  • To correctly write the configuration data sent from the body control module (BCM) to the adaptive front lighting system (AFS) control module, 30 s or more have to be elapsed since the ignition is switched ON (engine off or on).
  • DTCs are stored in the body control module (BCM).
    • Body control module (BCM) configuration not implemented
    • Body control module (BCM) internal memory malfunction
  • Body control module (BCM) configuration data error
  • Adaptive front lighting system (AFS) control module malfunction
System wiring diagram Not applicable
Connector diagram Not applicable
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.