2022 Mazda 3 BaseFACTORY OEM SERVICE PROCEDURE

DTC U212B-87: Communication Error With Body Control Module (BCM) [Adaptive Front Lighting System (AFS) Control Module]: Outline

WARNING: This page is about a different car, the 2021 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
DTC U212B:87 [ADAPTIVE FRONT LIGHTING SYSTEM (AFS) CONTROL MODULE] DETECTION CONDITION AND POSSIBLE CAUSE

System malfunction location Communication error with body control module (BCM)
Detection condition
  • The adaptive front lighting system (AFS) control module cannot receive CAN signal from the body control module (BCM).
Fail-safe
  • The swivel actuator is moved to the center.
  • The headlight leveling actuator is stopped at the position when the malfunction is determined.
Possible cause
  • Malfunction in CAN communication line between body control module (BCM) and adaptive front lighting system (AFS) control module
System wiring diagram Not applicable
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.