2022 Mazda 3 BaseFACTORY OEM SERVICE PROCEDURE

Active Command Modes Table [Adaptive Front Lighting System (AFS) Control Module]

WARNING: This page is about a different car, the 2021 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
SIMULATION ITEM DESCRIPTION

Simulation item Unit/Operation Data contents Output part name
AFS_SW_STAT Not Adopted/OFF/ON
  • Not Adopted: Adaptive front lighting system (AFS) not adopted.
  • OFF: Stops adaptive front lighting system (AFS) control module.
  • On: Operates adaptive front lighting system (AFS) control module.
Adaptive front lighting system (AFS)
REV_LAMP_STAT Off/On
  • Off: Diagnostic tester sends back-up light off signal to adaptive front lighting system (AFS) control module.
  • On: Diagnostic tester sends back-up light on signal to adaptive front lighting system (AFS) control module.
-
STR_ANG Β° (deg) Set steering angle signal (absolute angle).
  • Steering wheel in neutral position: Near 0 degrees
  • Steering wheel turned to left: Changes from 0 degrees to positive
  • Steering wheel turned to right: Changes from 0 degrees to negative
-
VSS km/h Set vehicle speed. -
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.