Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2022 Mazda 3 BaseFACTORY OEM SERVICE PROCEDURE
Wheel Alignment Pre-Inspection
WARNING: This page is about a different car, the 2021 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
- Park the vehicle on level ground in an unloaded condition* and with the wheels straight forward.
*Unloaded: Fuel tank is full, engine coolant and engine oil are at the specified level, and the spare tire, jack and tools are not loaded in the vehicle.
- Inspect the tire pressures.
- If necessary, adjust to the specified air pressure. (See SUSPENSION TECHNICAL DATA (US) .)
- Inspect the wheel bearing for play. (See WHEEL HUB, STEERING KNUCKLE INSPECTION
.) (See WHEEL HUB COMPONENT INSPECTION
.)
- If necessary, perform replacement. (See WHEEL HUB, STEERING KNUCKLE INSPECTION .) (See WHEEL HUB COMPONENT REMOVAL/INSTALLATION [2WD (US)] .) (See WHEEL HUB COMPONENT REMOVAL/INSTALLATION [AWD (US)] .)
- Inspect the wheel for run out.
- If necessary, perform repairs. (See SUSPENSION TECHNICAL DATA (US) .)
- If it is the maximum specification or more, repair or replace the wheel.
- Shake the body and inspect the steering ball joint and suspension ball joint for excessive play.
- Shake the body and verify that the shock absorbers operate correctly.
- Measure dimension H from the edge of the fender to the center of the wheel on both the left and right sides.
- Verify that the difference between dimension H on the left and right sides measured in Step 7 is within the standard.
Standard
10 mm {0.39 in} or less
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
