2022 Mazda 3 BaseFACTORY OEM SERVICE PROCEDURE

DTC U2300-55: Body Control Module (BCM) Configuration Not Implemented [Auto Leveling Control Module]: Outline

WARNING: This page is about a different car, the 2021 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
DTC U2300:55 (AUTO LEVELING CONTROL MODULE) DETECTION CONDITION AND POSSIBLE CAUSE

System malfunction location Body control module (BCM) configuration not implemented
Detection condition  
  • The auto leveling control module received a signal which indicates the body control module (BCM) configuration is not performed.
Fail-safe  
  • The headlight leveling actuator is stopped at the position when the malfunction is determined.
Possible cause  
NOTE:
  • To correctly write the configuration data sent from the body control module (BCM) to the auto leveling control module, 30 s or more have to be elapsed since the ignition is switched ON (engine off or on).
  • Body control module (BCM) configuration is not completed.
  • Body control module (BCM) malfunction
  • Auto leveling control module malfunction
System wiring diagram Not applicable
Connector diagram Not applicable
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.