Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2022 Mazda 3 BaseFACTORY OEM SERVICE PROCEDURE
Circuit Inspection Table
CIRCUIT INSPECTION
| Item | Reference |
|---|---|
| Inspection for Short to Ground and Open Circuit in Power Supply Circuit | (See Inspection for Short to Ground and Open Circuit in Power Supply Circuit .) |
| Inspection for Short to Ground in Circuit | (See Inspection for Short to Ground in Circuit .) |
| Inspection for Short to Power Supply in Circuit | (See Inspection for Short to Power Supply in Circuit .) |
| Inspection for Open Circuit in Circuit | (See Inspection for Open Circuit in Circuit .) |
| Inspection for Short Circuit in Circuits | (See Inspection for Short Circuit in Circuits .) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
