2021 Mazda MX-5 Miata Club, Automatic TransFACTORY OEM SERVICE PROCEDURE

Manifold Absolute Pressure (Map) Sensor/Intake Air Temperature (IAT) Sensor No. 2 Removal/Installation

NOTE:
  • The IAT sensor No. 2 is built into the MAP sensor. When replacing the IAT sensor No. 2, replace the MAP sensor/IAT sensor No. 2.
  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Wiper arm (See WIPER ARM AND BLADE REMOVAL/INSTALLATION .)
    2. Cowl grille (See COWL GRILLE REMOVAL/INSTALLATION .)
    3. Front suspension tower bar (Vehicles with front suspension tower bar) (See FRONT SUSPENSION TOWER BAR REMOVAL/INSTALLATION .)
    4. Air box complete (See AIR BOX COMPLETE REMOVAL/INSTALLATION .)
  3. Disconnect the MAP sensor/IAT sensor No. 2 connector.
  4. Remove the screw.
    G11274189Courtesy of MAZDA MOTORS CORP.
  5. Remove the MAP sensor/IAT sensor No. 2.
  6. Install in the reverse order of removal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.