2021 Mazda MX-5 Miata Club, Automatic TransFACTORY OEM SERVICE PROCEDURE

Resistance Inspection

  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Seal cover (See SEAL COVER REMOVAL/INSTALLATION .)
    2. Front suspension tower bar (Vehicles with front suspension tower bar) (See FRONT SUSPENSION TOWER BAR REMOVAL/INSTALLATION .)
    3. Intake manifold (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION .)
  3. Disconnect the KS connector.
  4. Remove the bolt. (See KNOCK SENSOR (KS) REMOVAL/INSTALLATION .)
  5. Remove the KS. (See KNOCK SENSOR (KS) REMOVAL/INSTALLATION .)
  6. Measure the resistance between KS terminals A and B.
    G13488476Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.