2021 Mazda CX-3 AWDFACTORY OEM SERVICE PROCEDURE

Front Abs Wheel-Speed Sensor Removal/Installation: Notes

WARNING: This page is about a different car, the 2016 Mazda CX-3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove in the order indicated in the figure.
  2. Install in the reverse order of removal.
  3. After installation, verify that there is no twisting in the front ABS wheel-speed sensor.
Fig 1: Front ABS Wheel-Speed Sensor Components With Torque Specifications
G10909732Courtesy of MAZDA MOTORS CORP.
COMPONENT DESCRIPTION

1 Connector
(See Connector Disconnection NoteΒ .)
2 Bolt
3 Front ABS wheel-speed sensor
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.