Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Mazda CX-3 AWDFACTORY OEM SERVICE PROCEDURE
Auto Wiper System
WARNING: This page is about a different car, the 2016 Mazda CX-3. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- There Are Two Types Of Personalization Procedures; One Using The M-Mds And The Other Using The Center Display.
| Personalization Features | Setting Contents | Setting Procedure | ||
|---|---|---|---|---|
| The Auto Wiper Function Can Be Disabled. | Off(1) (Intermittent)/On (Rain Sensing) | M-Mds Is Used. (See Control System Personalization Features Setting Procedure .) |
||
| On/Off(1) | Center Display Is Used For The Setting. (See Center Display Personalization Features Setting Procedure .) |
|||
|
||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.