2021 Mazda CX-3 AWDFACTORY OEM SERVICE PROCEDURE

Wheel Alignment Pre-Inspection

WARNING: This page is about a different car, the 2016 Mazda CX-3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Park the vehicle on level ground, in an unloaded condition*, with the wheels straight forward.

    *: Unloaded condition, fuel tank is full. Engine coolant and engine oil are at specified level. Spare tire, jack and tools are in designated position.

  2. Inspect the tire pressure.
  3. Inspect the wheel bearing play.
  4. Inspect the wheel runout.
    • Correct if necessary. (Refer to SUSPENSION TECHNICAL DATA .)
    • If it is the maximum specification or more, replace or replace the wheel.
  5. Rock the vehicle, and verify that there is no looseness in the steering wheel joint and suspension ball joint.
  6. Rock the vehicle, and verify that the shock absorber operates properly.
  7. Measure height H from the center of the wheel to the fender brim.
    Fig 1: Fender Brim Height Dimensions
    G10909311Courtesy of MAZDA MOTORS CORP.
  8. Verify that the difference between the left and right dimension H is within the specification.
    • If it exceeds the specification, repeat the Step 2-7.

      Standard Specification 

    • 10 mm {0.39 in} or less
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.