Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Mazda CX-3 AWDFACTORY OEM SERVICE PROCEDURE
Total Toe-In Adjustment
WARNING: This page is about a different car, the 2016 Mazda CX-3. However, it is still accessible from the selected car via links, so may be relevant.
- Loosen the locknut of the tie-rod end.
- Remove the boot clamp.
- Adjust the total toe-in by rotating each tie rod (left and right) in the opposite directions by the same amount respectively.NOTE:
- Toe angle changes by Aprox. 7 mm {0.3 in} in per one rotation of the tie rod for one wheel.
- Each tie rod has a right-hand thread.
- Tighten the locknut of the tie-rod end.
Tightening Torque
- 69-98 N.m {7.1-9.9 kgf.m, 51-72 ft.lbf}
- Verify that the boot does not have any twisting and install the boot clamp.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
