Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Mazda CX-3 AWDFACTORY OEM SERVICE PROCEDURE
Section 12 (Control System - Auto A/C)
WARNING: This page is about a different car, the 2016 Mazda CX-3. However, it is still accessible from the selected car via links, so may be relevant.
- HVAC Control System Location Index (Auto A/C)
- Air Intake Actuator Removal/Installation (Auto A/C)
- Air Intake Actuator Inspection (Auto A/C)
- Air Mix Actuator Removal/Installation (Auto A/C)
- Air Mix Actuator Inspection (Auto A/C)
- Airflow Mode Actuator Removal/Installation (Auto A/C)
- Airflow Mode Actuator Inspection (Auto A/C)
- Solar Radiation Sensor Removal/Installation (Auto A/C)
- Solar Radiation Sensor Inspection (Auto A/C)
- Ambient Temperature Sensor Removal/Installation (Auto A/C)
- Ambient Temperature Sensor Inspection (Auto A/C)
- Passenger Compartment Temperature Sensor Removal/Installation (Auto A/C)
- Passenger Compartment Temperature Sensor Inspection (Auto A/C)
- Evaporator Temperature Sensor Removal/Installation (Auto A/C)
- Evaporator Temperature Sensor Inspection (Auto A/C)
- Refrigerant Pressure Sensor Removal/Installation (Auto A/C)
- Refrigerant Pressure Sensor Inspection (Auto A/C)
- Climate Control Unit Removal/Installation (Auto A/C)
- Climate Control Unit Inspection (Auto A/C)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.