2021 Mazda CX-3 AWDFACTORY OEM SERVICE PROCEDURE

No. 23 A/C Does Not Work Sufficiently: Notes

23 A/C DOES NOT WORK SUFFICIENTLY
DESCRIPTION
  • A/C compressor magnetic clutch does not engage when A/C switch is turned on.
POSSIBLE CAUSE
  • PCM, instrument cluster or climate control unit DTC is stored
  • Refrigerant pressure sensor malfunction
  • Improper refrigerant charging amount
  • Seized A/C compressor
  • Evaporator temperature sensor malfunction
  • Open or short circuit in wiring harness between the following terminals:
    • Evaporator temperature sensor terminal B-Instrument cluster terminal 2O (with manual air conditioner system (4-speed type airflow volume control dial))
    • Evaporator temperature sensor terminal A-Instrument cluster terminal 2P (with manual air conditioner system (4-speed type airflow volume control dial))
    • Evaporator temperature sensor terminal B-Climate control unit terminal G (with manual air conditioner system (7-speed type airflow volume control dial))
    • Evaporator temperature sensor terminal A-Climate control unit terminal J (with manual air conditioner system (7-speed type airflow volume control dial))
    • Evaporator temperature sensor terminal B-Climate control unit terminal J (with full-auto air conditioner system (type A (VIN serial No. 100001-)))
    • Evaporator temperature sensor terminal A-Climate control unit terminal E (with full-auto air conditioner system (type A (VIN serial No. 100001-)))
    • Evaporator temperature sensor terminal B-Climate control unit terminal R (with full-auto air conditioner system (type B (VIN serial No. 300001-)))
    • Evaporator temperature sensor terminal A-Climate control unit terminal D (with full-auto air conditioner system (type B (VIN serial No. 300001-)))
  • Instrument cluster malfunction (Does not receive A/C request signal from climate control unit or transmit it to PCM)
  • Climate control unit malfunction (A/C switch malfunction or climate control unit does not determine A/C request or transmit A/C request signal)
  • Open circuit in wiring harness between magnetic clutch and body ground
  • A/C relay stuck open
  • Open circuit in wiring harness between the following terminals:
    • IG1 relay terminal C-A/C relay terminal A
    • Battery positive terminal-A/C relay terminal C
    • A/C relay terminal E-PCM terminal 2AF
    • A/C relay terminal D-Magnetic clutch terminal A
G13148972Courtesy of MAZDA MOTORS CORP.
G13148973Courtesy of MAZDA MOTORS CORP.
CAUTION:
  • Verify the malfunction symptom according to not only the PID value but also the symptom troubleshooting.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.