Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Mazda CX-3 AWDFACTORY OEM SERVICE PROCEDURE
A/C Cut-off Control System Inspection
- Start the engine.
- Turn the A/C switch and fan switch (with manual air conditioner system) on.
- Verify that the A/C compressor magnetic clutch actuates.
- If it does not actuate, perform the symptom troubleshooting "NO. 23 A/C DOES NOT WORK SUFFICIENTLY". (See NO. 23 A/C DOES NOT WORK SUFFICIENTLY .)
- Fully open the throttle valve and verify that the A/C compressor magnetic clutch does not actuate for 2-5 s.
- If it actuates, inspect the following:
- A/C relay (See RELAY INSPECTION .)
- Open or short to ground in wiring harness and connectors (IG1 relay-A/C relay-PCM terminal 2AF)
- A/C related parts
- APP1, APP2 PIDs (See PCM INSPECTION .)
- If it actuates, inspect the following:
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.