2021 Mazda CX-3 AWDFACTORY OEM SERVICE PROCEDURE

Oil Cooler Removal/Installation: Notes

WARNING:
  • Hot engines and engine oil can cause severe burns. Turn off the engine and wait until it and the engine oil have cooled.
  • A vehicle that is lifted but not securely supported on safety stands is dangerous. It can slip or fall, causing death or serious injury. Never work around or under a lifted vehicle if it is not securely supported on safety stands.
  • Continuous exposure to USED engine oil has caused skin cancer in laboratory mice. Protect your skin by washing with soap and water immediately after working with engine oil.
  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
  2. Remove the front under cover No. 2. (See FRONT UNDER COVER NO. 2 REMOVAL/INSTALLATION .)
  3. Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT .)
  4. Remove in the order indicated in the table.
  5. Use a clean rag to wipe off the mounting surface on the oil filter body and the oil cooler.
  6. Install in the reverse order of the removal.
  7. Refill the engine coolant. (See ENGINE COOLANT REPLACEMENT .)
  8. Start the engine and confirm that there is no oil leakage.
    • If there is oil leakage, repair or replace the applicable part.
  9. Inspect the oil level. (See ENGINE OIL LEVEL INSPECTIONΒ .)
  10. Inspect for engine coolant leakage. (See ENGINE COOLANT LEAKAGE INSPECTION .)
Fig 1: Oil Cooler Components With Torque Specification
G13149301Courtesy of MAZDA MOTORS CORP.
COMPONENT DESCRIPTION

1 Water hose
2 Oil cooler
(See Oil Cooler Installation NoteΒ .)
3 Gasket
(See Gasket Installation NoteΒ .)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.