Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Mazda CX-3 AWDFACTORY OEM SERVICE PROCEDURE
Brake Fluid Pressure Sensor Inspection
- Switch the ignition off.
- Disconnect the brake pipe from the LF brake hose.
- Install the SSTs to the brake pipe as shown in the figure.
- Bleed the brake line and the SSTs of air. Bleed the air form the SSTs using bleeder screw A.
- Connect the M-MDS to the DLC-2.
- Select the "BRK_F_P_R" PID.
- Start the engine.
- Depress the brake pedal, and confirm that the fluid pressure value of the SST (gauge) and the value shown on the M-MDS are equal.
- If the fluid pressures are different, replace the DSC HU/CM. (See DSC HU/CM REMOVAL/INSTALLATIONΒ .)
- After the inspection, remove the SSTs, install the brake hose and brake pipe to the original positions. (See FRONT BRAKE HOSE REMOVAL/INSTALLATION .)
- Bleed the air from the brake line. (See BRAKE FLUID AIR BLEEDING .)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
