2021 Mazda CX-3 AWDFACTORY OEM SERVICE PROCEDURE

Rear Power Window Regulator Removal/Installation

  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Power window subswitch (rear-side) (See POWER WINDOW SUBSWITCH REMOVAL/INSTALLATIONΒ .)
    2. Rear door trim (See REAR DOOR TRIM REMOVAL/INSTALLATION .)
    3. Rear power window motor (See REAR POWER WINDOW MOTOR REMOVAL/INSTALLATIONΒ .)
    4. Rear door glass (See REAR DOOR GLASS REMOVAL/INSTALLATIONΒ .)
  3. Remove the nuts.
    Fig 1: Rear Power Window Regulator Nuts With Torque Specification
    G13152158Courtesy of MAZDA MOTORS CORP.
  4. Insert your hand through the service hole and support the drum housing.
    G13152159Courtesy of MAZDA MOTORS CORP.
  5. Move the clip tabs in the direction of arrow (1) shown in the figure to detach the tabs, and move the clip in the direction of arrow (2) to remove.
  6. Remove the rear power window regulator through the service hole.
    CAUTION:
    • When removing the rear power window regulator, the rear power window regulator may contact the service hole, and the coating film of the rear door inner panel and the rear power window regulator could be damaged. Remove the rear power window regulator while verifying that the rear power window regulator and the service hole do not contact each other.
    G13152160Courtesy of MAZDA MOTORS CORP.
  7. Install in the reverse order of removal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.