Connect the M-MDS to DLC-2.
After the vehicle is identified, select the following items from the initial screen of the M-MDS.
1. Select the "Module Programming".
2. Select "Programmable Parameters".
Select menu in the SSU.
Select an item name, and then select option.

SETTING PROCEDURE

M-MDS display

Function

Initial setting

Setting contents

Control unit

Advanced keyless function. ⁽¹⁾

The advanced keyless entry system and push button start system functions can be disabled.

Enabled.

Enabled./Disabled.

Start stop unit

Walk Away Lock.

The out-of-area (reception area) type auto lock function can be set.

OFF

OFF/ON

Start stop unit

Auto Relock Time.

The operation start time of the auto re-lock function can be changed.

60 seconds

30 seconds/60 seconds/90 seconds

Start stop unit

Keyless Lock Beep Volume.

The keyless beeper volume can be adjusted.

Medium

Off/Low/Medium/High

Start stop unit

⁽¹⁾	Because the push button start system function has been disabled, to start the engine press the upper part of the remote transmitter against the center of the push button start.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Using M-MDS