Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Mazda 6 Carbon EditionFACTORY OEM SERVICE PROCEDURE
Power Window System Initialization Procedure
NOTE:
- If the following operations have been performed, the initial window setting is reset, and auto up/down operations are disabled. Therefore, re-establishing the initial setting is necessary.
- Negative battery cable is disconnected.
- Power window main switch connector is disconnected.
- Power window system power supply fuse is removed.
- Power window subswitch connector is disconnected.
- Switch the ignition ON (engine off).
- Press the power window main switch or power window subswitch to fully open the door glass.
- Pull up and hold the power window main switch or power window subswitch until the door glass is fully closed. Once fully closed, keep holding the switch up for approx. 2 s.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.