Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Mazda 6 Carbon EditionFACTORY OEM SERVICE PROCEDURE
Power Window Main Switch Removal/Installation
- Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
- Move the power window main switch component in the direction of the arrow and detach the tabs and hook.
- Move the power window main switch component in the direction of the arrow and detach the pin.
- Move the power window main switch component in the direction of arrows (1), (2) and detach the tabs.
- Disconnect the connectors.
- Remove the power window main switch component from the front door trim.
- Using a tape-wrapped flathead screwdriver, move the power window main switch cover end in the direction of arrow (1) shown in the figure, and detach the tab while moving the power window main switch in the direction of arrow (2).
- Detach the tabs in the same manner as Step 7.
- Remove the power window main switch from the power window main switch cover.
- Install in the reverse order of removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.