Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Mazda 3 BaseFACTORY OEM SERVICE PROCEDURE
ECT Sensor No. 1
WARNING: This page is about a different variant/trim than selected.
- Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION (US) .)
- Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT .)
- Remove the following parts:
- Plug hole plate (See PLUG HOLE PLATE REMOVAL/INSTALLATION .)
- Battery (See BATTERY REMOVAL/INSTALLATION .)
- Battery tray (See BATTERY REMOVAL/INSTALLATION .)
- Air inlet pipe (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION .)
- Disconnect the ECT sensor No. 1 connector.
- Remove the ECT sensor No. 1 using the SST.
- Install in the reverse order of removal.
- Refill the engine coolant. (See ENGINE COOLANT REPLACEMENT .)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
