2021 Mazda 3 BaseFACTORY OEM SERVICE PROCEDURE

Control Cables (Shift Lever Side) Installation Note

WARNING: This page is about a different variant/trim than selected.
  1. Verify that the shift lever is in the neutral position.
  2. Connect the control cables to the shift lever.
    G13176467Courtesy of MAZDA MOTORS CORP.
  3. Install the control cable end (shift side) using the following procedure.
    G13176468Courtesy of MAZDA MOTORS CORP.
    1. Point the projection of the control cable end (shift side) towards the upper side of the vehicle.
    2. Point the marking of the control cable end (shift side) towards the right side of the vehicle.
    3. Install the control cable end (shift side).
      NOTE:
      • Because the vehicle may have been moved during the servicing, verify that the shift lever is in neutral again.
  4. Install the control cable end (select side) to the shift lever so that the projection of the lock piece is positioned on the left side of the vehicle.
  5. Verify that the shift lever and the manual transaxle are in the neutral position.
  6. Shift the shift lever to fourth gear.
  7. Press in the lock piece in the direction shown in the figure.
    G13176469Courtesy of MAZDA MOTORS CORP.
  8. Shift the shift lever to the neutral position.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.