2021 Mazda 3 BaseFACTORY OEM SERVICE PROCEDURE

Control Cable Ends (Transaxle Side) Installation Note

WARNING: This page is about a different variant/trim than selected.
  1. Verify that the shift control module is in the neutral position.
    CAUTION:
    • Pull the lock pin within the range shown in the figure. If the lock pin is pulled excessively, it could deform and no longer function.
    G13176465Courtesy of MAZDA MOTORS CORP.
  2. Install the lock pin to the groove of the control cable end.
    G13176466Courtesy of MAZDA MOTORS CORP.
  3. Connect the control cable end to the manual transaxle.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.