Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Mazda 3 BaseFACTORY OEM SERVICE PROCEDURE
Instrument Cluster Removal/Installation
CAUTION:
- When replacing the instrument cluster, perform the configuration to assure that the system operates correctly.
- To replace the instrument cluster, perform the following procedure.
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off).
- Activate the MMDS and perform the following procedure.
- Press [Start] to start the vehicle identification.
- Press the [Toolbox] tab.
- Press the [Work Support] icon.
- Press [Configuration].
- Press [Run] to perform the configuration.
- Press [IC].
- When [Install the new ECU] is displayed, move to the instrument cluster replacement procedure.
- Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION (US) .)
- Remove the following parts:
- Driver-side front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
- Driver-side front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
- Driver-side decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION .)
- Passenger-side decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION .)
- Hood release lever (See HOOD RELEASE LEVER AND RELEASE CABLE REMOVAL/INSTALLATION (US) .)
- Driver-side lower panel (See LOWER PANEL REMOVAL/INSTALLATION (US) .)
- Upper column cover (See COLUMN COVER REMOVAL/INSTALLATION .)
- Remove the screws.
- Disconnect the connector.CAUTION:
- If the instrument cluster is left for a long time with its screen facing down, grease applied to the needles may spill and the needles may not operate smoothly. When storing the instrument cluster, store it with its screen facing upward.
- Remove the instrument cluster by sliding it between the dashboard and the steering wheel.
- Install in the reverse order of removal.
- If the instrument cluster is replaced, perform the following procedure.
- Return to the M-MDS operation and press [Continue].
- When the M-MDS processing is completed, press [Next].
- When the M-MDS processing is completed, press [Next].
- Verify that the following conditions/operations are met/completed, mark the check boxes, and then press [Next].
- Ignition is switched ON (engine off)
- Install battery charger to vehicle
- Battery voltage:11.6 V or more
- Connect power cable to M-MDS
- Front doors on both sides and trunk lid (Sedan-4SD) or liftgate (Hatchback-5HB) are open
- Press [Finish].
- Switch the ignition OFF.
- Switch the ignition ON (engine off) to complete global central configuration (GCC) for the instrument cluster.
- Clear the DTC. (See CLEARING DTC .)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
