2020 Mazda CX-30 Base, AWDFACTORY OEM SERVICE PROCEDURE

Pcm Removal/Installation

CAUTION:
  • There are two types of PCM settings. If the incorrect PCM is installed, it could cause interference with engine control.
  • When replacing the PCM, verify the first four digits of the part number indicated on the PCM label before replacement, and replace the PCM with one having the same part number.
G13175492Courtesy of MAZDA MOTORS CORP.
  • When replacing the PCM, perform the configuration to assure that the system operates correctly. (See CONFIGURATION .)
  1. When replacing the PCM, perform manual configuration using the following procedure.
    1. Verify the personalization feature setting values with the customer.
    2. Connect the M-MDS to the DLC-2.
    3. Switch the ignition ON (engine off or on).
    4. Perform vehicle identification.
    5. Select [Configuration] using the M-MDS.
    6. Select [PCM].
    7. Perform manual configuration following the instructions on the screen.
  2. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION (US) .)
  3. Remove the PCM together with the battery tray as a single unit. (See BATTERY REMOVAL/INSTALLATION .)
  4. Remove in the order indicated in the table.
  5. Install in the reverse order of removal.
  6. If the PCM is replaced, perform the following procedure.
  1. Perform manual configuration following the instructions on the M-MDS screen.
    • If manual configuration is performed using the As-Built data, the set values for the personalization features may be reset to the initial values (condition when shipped from factory). Perform the personalization features setting after performing the manual configuration.
  2. Perform the immobilizer system-related part programming using the M-MDS. (See IMMOBILIZER SYSTEM-RELATED PARTS PROGRAMMING (US) .)
  3. Perform the battery condition initial setting (i-stop setting).
  4. If the configuration is performed using the As-Built data, write the coupling component characteristic value. (AWD) (See COUPLING COMPONENT CALIBRATION DATA WRITING .)
  5. Perform the DTC inspection. (See DTC INSPECTION .)
    • If the DTC is displayed again, repair the malfunctioning location according to the applicable DTC troubleshooting.
    Fig 1: PCM Components With Torque Specification
    G13557679Courtesy of MAZDA MOTORS CORP.
    COMPONENT DESCRIPTION

    1 PCM
    2 PCM bracket
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.