Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2020 Mazda 3 Base, 4D Hatchback, AWDFACTORY OEM SERVICE PROCEDURE
Power Window System Initialization Procedure
NOTE:
- If the following operations have been performed, the initial setting is reset, and auto up/down operation are disabled. Therefore, performing the initial setting is necessary.
- Door-electrical supply unit is replaced.
- Inching operation is performed 10 times using power window main switch or power window subswitch.
- Door glass is removed.
- Switch the ignition ON (engine on or off).
- Press the power window main switch or power window subswitch to fully open the door glass.
- Pull up the power window main switch or power window subswitch to the manual-up position to fully close the door glass and keep holding the switch up at the position for approx. 2 s.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
