Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2020 Mazda 3 Base, 4D Hatchback, AWDFACTORY OEM SERVICE PROCEDURE
Power Outer Mirror Removal/Installation: Notes
- Fully lower the front door glass.
- Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION [(US)] .)
- Remove the following parts:
- Front door speaker grille (See SPEAKER GRILLE REMOVAL/INSTALLATION .)
- Inner garnish (See INNER GARNISH REMOVAL/INSTALLATION .)
- Power window main switch (to remove from driver's side) (See POWER WINDOW MAIN SWITCH REMOVAL/INSTALLATION .)
- Power window subswitch (front) (to remove from passenger's side) (See POWER WINDOW SUBSWITCH REMOVAL/INSTALLATION .)
- Front door trim (See FRONT DOOR TRIM REMOVAL/INSTALLATION [(US)] .)
- Disconnect the connectors.
- Move a tape-wrapped flathead screwdriver in the direction of the arrow shown in the figure and detach the hooks from the front door panel.
- Remove the service hole cover.
- Remove the bolts.CAUTION:
- If clip of the power outer mirror is detached, the power outer mirror may fall off and be damaged. When detaching clip of the power outer mirror, hold the power outer mirror by hand during the servicing.
- Pull the power outer mirror in the direction of the arrow while removing the clip and pins.
- Remove the power outer mirror.
- Install in the reverse order of removal. (See POWER OUTER MIRROR INSTALLATION NOTE .) (See CLIP REPLACEMENT NOTE .)
- Perform the 360° view monitor system aiming. (with side camera) (See 360° VIEW MONITOR SYSTEM AIMING .)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
