Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Mazda 6 Grand TouringFACTORY OEM SERVICE PROCEDURE
On-Board Diagnostics - Position Memory Control Module
- Forward (Position Memory Control Module)
- Clearing DTC (Position Memory Control Module)
- DTC B1B87-13: Lift Motor And Position Sensor Circuit Malfunction
- DTC B1B89-13: Slide Motor And Position Sensor Circuit Malfunction
- DTC B1B91-13: Tilt Motor And Position Sensor Circuit Malfunction
- DTC B1B93-13: Recliner Motor And Position Sensor Circuit Malfunction
- DTC Inspection (Position Memory Control Module)
- DTC Table (Position Memory Control Module)
- DTC U0001-88, U0100-00, U0101-00, U0151-00, U0155-00, U0214-00: Communication Error
- DTC U3003-16: Position Memory Control Module Power Supply Voltage Low Input
- On-Board Diagnostic Wiring Diagram (Position Memory Control Module)
- PID/Data Monitor Inspection (Position Memory Control Module)
- PID/Data Monitor Table (Position Memory Control Module)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
