Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Mazda 3 Preferred, 4D Hatchback, AWDFACTORY OEM SERVICE PROCEDURE
Function Inspection
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off).
- Display the PIDs MAP_VOLT and MAP. (See PID/DATA MONITOR INSPECTION .)
- Compare the voltage and manifold absolute pressure indications for the PIDs MAP_VOLT and MAP with the standard in the table indicated below.
- If they do not match the standard, perform the voltage inspection. (See VOLTAGE INSPECTION .)
Standard
MANIFOLD ABSOLUTE PRESSURE SPECIFICATION
| MAP_VOLT | MAP | Remarks |
|---|---|---|
| V | kPa {kgf/cm2 , psi} | |
| Approx. 4.04 | 100 {1.02, 14.5} | Ignition switched ON (engine off) |
| Approx. 1.40 | 35 {0.36, 5.1} | Idle (after warm up) |
| Approx. 1.01 | 26 {0.27, 3.8} | Racing (Engine speed: 2, 000 RPM) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.