Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Mazda 6 Grand TouringFACTORY OEM SERVICE PROCEDURE
Auto Leveling Control Module DTCS
AUTO LEVELING CONTROL MODULE DTCS
| DTC No. | Description | Refer To |
|---|---|---|
| B1D00:13 | Headlight (LH) circuit malfunction | (See DTC B1D00:13 (AUTO LEVELING CONTROL MODULE) .) |
| B1D01:13 | Headlight (RH) circuit malfunction | (See DTC B1D01:13 (AUTO LEVELING CONTROL MODULE) .) |
| C0061:54 | Acceleration sensor initial position learning not completed | (See DTC C0061:54 (AUTO LEVELING CONTROL MODULE) .) |
| U0001:88 | Unit communication error (HS-CAN) | (See DTC U0001:88/U0100:00/U0140:00/U0155:00 (AUTO LEVELING CONTROL MODULE) .) |
| U0100:00 | Communication error with PCM | |
| U0140:00 | Communication error with front body control module (FBCM) | |
| U0155:00 | Communication error with instrument cluster | |
| U0423:68 | Error signal received from instrument cluster | (See DTC U0423:68 (AUTO LEVELING CONTROL MODULE) .) |
| U2005:86 | Error signal received from PCM | (See DTC U2005:86 (AUTO LEVELING CONTROL MODULE) .) |
| U2300:54 | Error configuration data received from instrument cluster | (See DTC U2300:54 (AUTO LEVELING CONTROL MODULE) .) |
| U2300:55 | Instrument cluster configuration not implemented | (See DTC U2300:55 (AUTO LEVELING CONTROL MODULE) .) |
| U2300:56 | Configuration data unmatched with instrument cluster | (See DTC U2300:56 (AUTO LEVELING CONTROL MODULE) .) |
| U3000:42 | Auto leveling control module internal malfunction | (See DTC U3000:42 (AUTO LEVELING CONTROL MODULE) .) |
| U3003:16 | Auto leveling control module low power supply voltage input | (See DTC U3003:16 (AUTO LEVELING CONTROL MODULE) .) |
| U3003:17 | Auto leveling control module high power supply voltage input | (See DTC U3003:17 (AUTO LEVELING CONTROL MODULE) .) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
