Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Mazda 6 Grand TouringFACTORY OEM SERVICE PROCEDURE
Fuel Injection Control (-) Signal
PCM terminals
- Fuel Injection No. 1: 1DO(+)-body ground(-)
- Fuel Injection No. 2: 1DW(+)-body ground(-)
- Fuel Injection No. 3: 1EA(+)-body ground(-)
- Fuel Injection No. 4: 1DS(+)-body ground(-)
Oscilloscope setting
- 20 V/DIV (Y), 50 ms/DIV (X), DC range
Vehicle condition
- Idle after warm up
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
