2018 Mazda 6 Grand TouringFACTORY OEM SERVICE PROCEDURE

Function Inspection

  1. Connect the M-MDS to the DLC-2.
  2. Switch the ignition ON (engine off).
  3. Display the PID MAF. (See ON-BOARD DIAGNOSTIC TEST .) (See PCM INSPECTION .)
  4. Compare the voltage and flow rate indications for the PID MAF with the standard in the table indicated below.
    • If they do not match the standard, perform the voltage inspection. (See Voltage Inspection .)

Standard 

VOLTAGE SPECIFICATION

MAF Remarks
V   g/s {lb/min}
Approx. 0.72 0.65 {0.086} Ignition switched ON (engine off)
Approx. 0.86 2.78 {0.368} Idle (after warm up)
Approx. 1.14 7.74 {1.02} Racing (Engine speed: 2, 000 rpm)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.