Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Mazda 6 Grand TouringFACTORY OEM SERVICE PROCEDURE
Resistance Inspection
- Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
- Remove the boost pressure sensor/boost air temperature sensor. (See BOOST PRESSURE SENSOR/BOOST AIR TEMPERATURE SENSOR REMOVAL/INSTALLATION .)
- Measure the resistance between boost pressure sensor/boost air temperature sensor terminals A and B.Fig 1: Measuring Resistance Between Boost Pressure Sensor/Boost Air Temperature Sensor Terminals A And B
Courtesy of MAZDA MOTORS CORP.
- If not as specified, replace the boost pressure sensor/boost air temperature sensor. (See BOOST PRESSURE SENSOR/BOOST AIR TEMPERATURE SENSOR REMOVAL/INSTALLATION .)
Specification (Reference)
RESISTANCE SPECIFICATION
| IAT (°C {°F}) | Resistance (Kilohms) |
|---|---|
| 0 {32} | Approx. 5.9 |
| 20 {68} | Approx. 2.5 |
| 80 {176} | Approx. 0.323 |
| 130 {266} | Approx. 0.0893 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
