Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Mazda 6 Grand TouringFACTORY OEM SERVICE PROCEDURE
Multiplex Communication System DTCS: Ms-Can
MS-CAN DIAGNOSTIC TROUBLE CODE IDENTIFICATION
| DTC output module (M-MDS display) | DTC | Malfunction location | Malfunction location |
|---|---|---|---|
| Instrument cluster (IC) | U0010:88 | Unit communication error | (See DTC TABLE [INSTRUMENT CLUSTER] .) |
| U0142:00 | Communication error with rear body control module (RBCM) | ||
| U0232:00 | Communication error with blind spot monitoring (BSM) control module (LH) | ||
| Climate control unit (EATC) | U0010:88 | Unit communication error | (See DTC TABLE [CLIMATE CONTROL UNIT (FULL-AUTO AIR CONDITIONER)]
.) (See DTC TABLE [CLIMATE CONTROL UNIT (MANUAL AIR CONDITIONER)] .) |
| U0155:00 | Communication error with instrument cluster | ||
| Blind spot monitoring (BSM) control module (LH) | U0010:88 | Unit communication error | (See DTC TABLE [BLIND SPOT MONITORING (BSM) CONTROL MODULE] .) |
| U0100:00 | Communication error with PCM | ||
| U0155:00 | Communication error with instrument cluster | ||
| U0214:00 | Communication error with start stop unit | ||
| Rear body control module (RBCM) (R_BCM) | U0010:88 | Unit communication error | (See DTC TABLE [REAR BODY CONTROL MODULE (RBCM)] .) |
| U0155:00 | Communication error with instrument cluster |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
