2017 Mazda 6 Grand TouringFACTORY OEM SERVICE PROCEDURE

Rear Abs Wheel-Speed Sensor Removal/Installation: Notes

  1. Switch the ignition ON (engine off).
  2. Release the electric parking brake.
  3. Switch the ignition off.
  4. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
  5. Remove the following parts:
    1. Trunk covering (See TRUNK COVERING REMOVAL/INSTALLATION .)
    2. Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION .)
    3. Trunk side pocket (See TRUNK SIDE POCKET REMOVAL/INSTALLATION .)
    4. Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION .)
  6. Disconnect the rear ABS wheel-speed sensor connector.
    Fig 1: Disconnecting Rear ABS Wheel-Speed Sensor Connector
    G11546508Courtesy of MAZDA MOTORS CORP.
  7. Press the grommet tabs in the direction of arrows (1) shown in the figure and detach them from the vehicle body.
  8. Press the grommet in the direction of arrow (2) shown in the figure and press out the rear ABS wheel-speed sensor toward the outside of the vehicle.
  9. Remove the wheel and tire. (See WHEEL AND TIRE REMOVAL/INSTALLATION .)
  10. Remove in the order indicated in the table.
  11. Install in the reverse order of removal.
  12. After installation, verify that there is no twisting in the rear ABS wheel-speed sensor.
Fig 2: Installing Rear ABS Wheel-Speed Sensor With Torque Specification
G11546509Courtesy of MAZDA MOTORS CORP.
COMPONENT DESCRIPTION

1 Electric parking brake motor gear unit connector
2 Bolt
3 Bolt
4 Bolt
5 Rear ABS wheel-speed sensor
(See Rear ABS Wheel-speed Sensor Removal NoteΒ .)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.