Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Mazda 5 GS, Automatic TransFACTORY OEM SERVICE PROCEDURE
Input/Turbine Speed Sensor Removal/Installation
CAUTION:
- Do not allow foreign material or water to penetrate the connector. Otherwise, it could cause poor contact and corrosion.
- If the removed input/turbine speed sensor installation bolt is reused, it may cause ATF leakage. Always use a new bolt.
- A sealant coating is applied to the input/turbine speed sensor installation bolt to prevent ATF leakage from the installation bolt hole which passes through the component.
- When installing the input/turbine speed sensor, verify that there is no foreign material on the sensor such as metal shavings. If there is foreign material on the sensor part for the input/turbine speed sensor such as metal shavings, the sensor output will malfunction due to magnetic flux and result in deterioration in the control.
- Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [MZR 2.5] .)
- Disconnect the negative battery cable.
- Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZR 2.5] .)
- Remove in the order shown in the figure.
- Install in the reverse order of removal.
Courtesy of MAZDA MOTORS CORP.
PART DESCRIPTION1 Connector 2 Input/turbine speed sensor 3 O-ring
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
