2017 Mazda 5 GS, Automatic TransFACTORY OEM SERVICE PROCEDURE

Drive Plate Removal/Installation: Notes

  1. Remove the transaxle. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATIONΒ .)
  2. Remove in the order shown in the figure.
  3. Install in the reverse order of removal.
    Fig 1: Drive Plate Components With Torque Specification
    G13727432Courtesy of MAZDA MOTORS CORP.
    PART DESCRIPTION

    1 Drive plate installation bolt
    (See DRIVE PLATE INSTALLATION BOLT REMOVAL NOTEΒ .)
    (See DRIVE PLATE INSTALLATION BOLT INSTALLATION NOTEΒ .)
    2 Backing plate
    3 Drive plate
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.