Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Mazda 5 GS, Automatic TransFACTORY OEM SERVICE PROCEDURE
When idling can be continued
- Disconnect the OCV connector.
- Warm up the engine and idle it.
- Apply battery voltage to the OCV and verify that the engine idles roughly or stalls.
- If the engine idles roughly or stalls, inspect the timing chain component (valve timing deviation).
- If the engine does not idle roughly or stalls, go to the next step.
- Remove the OCV and perform spool valve operation inspection. (See OIL CONTROL VALVE (OCV) REMOVAL/INSTALLATION
.)
- If not as specified, inspect the following:
- OCV (See OIL CONTROL VALVE (OCV) INSPECTION .)
- Harnesses and connectors between OCV and PCM open or short
- If as specified, inspect the following hydraulic passages for restriction or leakage or both:
- Oil pressure switch-OCV
- OCV-Camshaft
- Camshaft internal passage
- If they are normal, replace the camshaft pulley (with built-into variable valve timing actuator). (See VARIABLE VALVE TIMING ACTUATOR INSPECTION .)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
