Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Mazda 5 GS, Automatic TransFACTORY OEM SERVICE PROCEDURE
Filament Repair
- Clean the filaments using isopropyl alcohol.
- Affix tape along both sides of the filament to be repaired.
- Apply commercially available silver paint using a fine-tipped tool such as a small brush or a drawing pen.
- After 2-3 min, peel off the tape being careful not to damage the painted area.CAUTION:
- Do not operate the rear window defroster until the repaired area is completely dried to prevent a malfunction.
- Completely dry the repaired area referring the following:
- If the room temperature is 25°C {77°F}, leave it for 24 h.
- When using a hot air blower, dry for 30 min at 150°C {302°F}.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.