2016 Mazda MX-5 Miata Club, Automatic TransFACTORY OEM SERVICE PROCEDURE

Fuel Cut Control System Inspection

NOTE:
  • This inspection has to be performed after the Fuel Injector Operation Inspection.

If data monitor function of M-MDS is used: 

  1. Warm up the engine and idle it.
  2. Connect the M-MDS to the DLC-2.
  3. Select the RPM and the FUELPW PIDs. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 2.0)] .)
  4. Monitor both PIDs while performing the following steps:
    1. Depress the accelerator pedal and increase the RPM PID to 4, 000 rpm  .
    2. Quickly release the accelerator pedal (brake pedal is not depressed) and verify that the FUELPW PID is 0 msec, and 2-5 msec when the RPM PID drops below 1, 200 rpm.
RELATED PIDS

Item (definition) Unit/Condition Definition Condition/Specification (Reference)
FUELPW Sec Fuel injection pulse width (fuel injector energization time) output to fuel injector
  • Idle (after warm up): Approx. 1.8 ms (ECT is 92 °C {198 °F})
  • Racing (engine speed is 2, 000 rpm): Approx. 1.36 ms (ECT is 86 °C {187 °F})
  • Racing (engine speed is 4, 000 rpm): Approx. 0.87 ms (ECT is 84 °C {183 °F})
RPM RPM Engine speed
  • Displays engine speed

If data monitor function of M-MDS is not used: 

  1. Warm up the engine and idle it.
  2. Measure the fuel injector control signal wave profile using the oscilloscope while performing the following steps:
    1. Depress the accelerator pedal and increase the engine speed to 4, 000 rpm.
    2. Quickly release the accelerator pedal (brake pedal is not depressed) and verify that the wave profile constant B+, and the wave appears when the engine speed drops below 1, 200 rpm. (See PCM INSPECTION .)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.