2016 Mazda 6 Grand TouringFACTORY OEM SERVICE PROCEDURE

No. 2 Check Engine Light Illuminates: Notes

2 CHECK ENGINE LIGHT ILLUMINATES
DESCRIPTION 
  • Check engine light illuminates incorrectly.
POSSIBLE CAUSE 
  • Check engine light illuminates for emission-related concern (DTC is stored in PCM)
  • Short to ground in wiring harness between the following terminals:
    • Instrument cluster terminal B-Front body control module (FBCM) terminal 2K
    • Instrument cluster terminal D-Front body control module (FBCM) terminal 2I
    • Front body control module (FBCM) terminal 2P-PCM terminal 2AK
    • Front body control module (FBCM) terminal 2N-PCM terminal 2AL
  • Open circuit in wiring harness between the following terminals:
    • Instrument cluster terminal B-Front body control module (FBCM) terminal 2K
    • Instrument cluster terminal D-Front body control module (FBCM) terminal 2I
    • Front body control module (FBCM) terminal 2P-PCM terminal 2AK
    • Front body control module (FBCM) terminal 2N-PCM terminal 2AL
  • Instrument cluster malfunction
NOTE:
  • If the check engine light blinks at a steady rate, a misfire condition could possibly exist.
G10985016
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.